Best Carbon Spine Charts for Compound Bows: Based on Specs

Best Carbon Spine Charts for Compound Bows: Based on Specs

For compound bows, begin with the maker’s arrow spine chart, then move one spine stiffer for fast setups or heavy point and insert loads, and one spine weaker for slower bows or lighter front ends. Wrong spine hurts broadhead flight, tightens tune tolerance, and can waste arrows and time. This article shows how to read a carbon arrow spine chart and adjust for bow speed, cut length, front-end mass, and fixed-blade broadheads.

Top picks
Our pickPinals Archery 28 30 Inch 300 340 350 400 Spine Carbon Hunting Arrows | 0.003 Camo Arrow Shaft,for Compound Recurve Bow,

Pinals Archery 28 30 Inch 300 340 350 400 Spine –⁠ $59.98

Pinals · 30-inch · 0.003 straightness · Camo Carbon
$59.98
Price as of 10 Nov 2026
Drawback: Specific spine selection must match your compound bow draw weight.

View on Amazon →

Also greatGold Tip Hunter 340 Hunting Arrows (6 Pack), 2" Raptor Vanes

Gold Tip Hunter 340 Hunting Arrows (6 Pack) –⁠ $54.99

Gold Tip · 6-Pack · Raptor Vanes · Gold Tip
$54.99
Price as of 10 Nov 2026
Drawback: Pack contains only 6 arrows instead of 12.

View on Amazon →

As an Amazon Associate we earn from qualifying purchases. Prices and availability are accurate as of the date shown and are subject to change.

Quick comparison

ProductBadgeBest forPrice
Pinals Archery 28 30 Inch 300 340 350 400 Spine Carbon Hunting Arrows | 0.003 Camo Arrow Shaft,for Compound Recurve Bow,Pinals Archery 28 30 Inch 300 340 350 400 Spine CarbonPinalsOur pick30-inch · 0.003 straightness · Camo Carbon$59.98

Price as of 10 Nov 2026
View
Gold Tip Hunter 340 Hunting Arrows (6 Pack), 2" Raptor VanesGold Tip Hunter 340 Hunting Arrows (6 Pack), 2" Raptor VanesGold TipAlso great6-Pack · Raptor Vanes · Gold Tip$54.99

Price as of 10 Nov 2026
View
As an Amazon Associate we earn from qualifying purchases. Prices and availability are accurate as of the date shown and are subject to change.

Use the chart first, then check it against your bow speed, cut length, and front-end weight. If the chart falls between two sizes, hunting setups usually do better with the stiffer choice.

How we chose

This guide follows manufacturer chart logic, not brand-to-brand number matching. That matters because Easton, Gold Tip, Victory, Carbon Express, and Black Eagle do not all use the same selector style.

The practical filter is simple: start with peak draw weight, then adjust for finished arrow length, point plus insert weight, bow speed or IBO rating, and broadhead type. A setup that is long, fast, and heavy up front needs more caution than a short target build with a light point.

When a chart straddles two spine sizes, the choice leans stiffer for hunting, fixed blades, longer arrows, and faster bows. It leans weaker only when the chart, shaft length, and front-end mass all point that way.

Carbon spine decision sheet

Key points: Carbon spine decision sheet
Setup factorStarting spine cueBias
Draw weightUse peak draw weight, not hold weight, to start the chart read.Higher peak draw weight usually pushes stiffer.
Cut arrow length27-29 inches tends to stay closer to the chart center; 30-31 inches usually asks for more support.Longer cut arrows usually need stiffer spine.
Point + insert weight100 grains is the common baseline for many charts.Heavier front-end mass makes the arrow act weaker, so move stiffer if the load climbs.
Bow speed bandSlower bows can stay closer to chart center; faster bows often need a stiffer starting point.Faster and more aggressive cams push dynamic spine weaker, so bias stiffer.
Broadhead typeField points are the easiest baseline.Mechanical broadheads may stay close to field-point tuning; fixed blades often push the choice stiffer.
Recommended starting spineUse the maker’s current selector, then choose the adjacent size only if the setup clearly leans that way.Pick stiffer for hunting margin; pick weaker only when the whole setup supports it.

Use this sheet as a pre-buy screen when a chart lands between two sizes. It is not a universal replacement for the shaft maker’s selector.

What carbon arrow spine do I need for my compound bow?

Start with the arrow maker’s current chart for your exact shaft family, then adjust for peak draw weight, finished arrow length, and front-end mass. Lower spine numbers are stiffer shafts, and the chart is a starting point, not the final answer.

Static spine is measured by a standard deflection test: a 28-inch span is loaded with 1.94 pounds, and the measured deflection multiplied by 1,000 becomes the spine rating. A 500 spine arrow deflects 0.500 inches under that test.

That numbering is what confuses many beginners. A lower number means a stiffer shaft.

Why chart first, then adjust

Compound bow charts are built around peak draw weight and shaft length, but real flight depends on dynamic spine. Dynamic spine includes point weight, insert weight, bow speed, cam aggression, and broadhead type.

That is why two arrows with the same static spine can behave differently. A heavier point or insert, a faster cam, or a fixed blade can make the shaft act weaker in flight.

How do I read an arrow spine chart for compound bows?

Read the chart in this order: peak draw weight, cut arrow length, then any front-end changes that push the shaft weaker or stiffer. The best chart read is the one that matches your actual setup, not just your bow label.

30-40 lb setups use 500 spine at 27-29 inches. Another chart uses 350 spine for 60-70 lb setups at 27-28 inches.

Those examples show the basic pattern. More draw weight and more shaft length generally move the choice toward a stiffer shaft number, but the chart still depends on the maker’s system.

Use the chart as a starting point

If the chart gives one spine size and your bow is fast, your insert is heavy, or you plan to shoot fixed blades, treat that result as the lighter side of the decision. If the setup is short, slow, and field-point only, the chart center is usually safer.

Does arrow length change the spine I should buy?

Yes. Cut arrow length matters because longer arrows bend more under the shot and usually need a stiffer spine. Cut length is measured from the nock throat to the end of the shaft, not to the end of the point.

That measurement detail matters. A shaft cut to 31 inches can act different from the same shaft cut to 28 inches, even before point weight is added.

A common first-timer mistake is buying for bare draw weight only and ignoring the finished length. Suppose a 70 lb bow is set up with a 31-inch cut arrow and a fixed blade head; that setup usually deserves more caution than the same bow with a 27-inch field-point arrow.

How to bias the chart with length

Longer arrows usually move the selection toward a stiffer shaft number. Shorter arrows generally act stiffer and can move selection toward a weaker static spine number.

That is the safest way to handle the boundary between two sizes. Do not assume a shorter cut means a stiffer chart number.

How does point weight affect arrow spine on a compound bow?

Heavier point weight makes the arrow act weaker, so the shaft often needs a stiffer starting point. Many charts use 100 grains as the baseline, and a 25-grain increase over that baseline can change the chart read.

Point weight is part of dynamic spine, not static spine. That means the same shaft can behave differently with a 100-grain point than with a heavier hunting point.

Insert weight counts too, because it adds to front-end mass. A heavy insert can push the choice toward a stiffer shaft even if the chart looked acceptable at first glance.

Front-end mass and dynamic spine

Dynamic spine is the real-world result after point weight, insert weight, bow speed, cam aggression, and broadhead type are added to the setup. It is the number that shows up in flight, paper tears, and broadhead impact behavior.

That is why a chart-only answer can miss the mark. Heavy inserts and heavy points both load the front of the shaft and can make a borderline spine behave weak.

Should I choose a stiffer spine for broadheads?

Often, yes, especially for fixed blades. Field points are the easiest baseline, mechanical broadheads usually track closer to that baseline, and fixed blades are the most likely to expose a weak dynamic tune.

Broadheads do not change the shaft by magic. They expose tune problems that field points may hide.

If the setup already has a long cut length, a heavy insert, and a fixed blade, a stiffer starting spine is usually the safer move. That combination is where weak dynamic behavior shows up fastest.

When broadheads change the answer

Picture a 60 lb hunting bow with a 30-inch arrow, 100-grain point, and a standard insert. That setup may look fine on a chart, but swapping to a fixed blade can reveal that the arrow is on the weak side.

In that case, the next stiffer shaft is often the better hunting choice, even if bare shafts looked close enough with field points.

What spine should I use for a 70 lb compound bow?

For a 70 lb compound bow, start with the maker’s current selector and then check where your arrow length and front-end weight land.

That range shows why one universal answer does not work. A 70 lb bow with a shorter cut arrow can stay on a weaker static number than a 70 lb bow with a longer arrow and heavier front end.

For hunting, the safer bias is often stiffer if the chart straddles two sizes. Faster bows, aggressive cams, heavy inserts, and fixed blades all push in that direction.

Two setup examples

Say your 70 lb setup uses a 27-inch cut arrow, 100-grain point, and field points only. That will usually sit closer to the chart center than the same bow with a 31-inch shaft and a fixed blade.

Suppose the only change is a heavier insert. The arrow can act weaker even though the draw weight stays the same, which is why insert mass belongs in the decision process.

Why do some spine charts recommend two spine sizes?

They do that because the chart is trying to cover more than one variable at once. Draw weight, cut length, point mass, insert mass, bow speed, and broadhead type can push the answer in different directions.

Key points: Why do some spine charts recommend two spine sizes?

When a chart straddles two sizes, the safer hunting choice is usually the stiffer shaft, especially for fixed blades, faster bows, or longer arrows. The weaker static number only makes sense when the chart, length, and front-end mass all agree.

How to choose between adjacent sizes

  1. Check the maker’s chart for your shaft family.
  2. Confirm peak draw weight, not hold weight.
  3. Measure cut length from nock throat to end of shaft.
  4. Add point weight and insert weight together.
  5. Bias stiffer for fixed blades, faster bows, or long shafts.
  6. Choose weaker only when the setup is clearly light up front and not especially fast.

How do I know if my arrows are too weak or too stiff?

Too weak and too stiff both show up in tune and broadhead flight, but the details depend on the bow and rest setup. Weak dynamic spine often shows more drama with fixed blades, while a shaft that is too stiff can also refuse to group cleanly and can be hard to tune.

The first check is paper tune, then bare shaft tune, then broadhead tune. If field points and broadheads do not agree, the spine choice may be off or the bow may need a tune adjustment.

Bad spine choice usually reduces tune margin. That is why a chart answer should be treated as a starting point, not a final verdict.

Easton: best for broad compatibility

Key points: Easton: best for broad compatibility

Keep reading

As an Amazon Associate we earn from qualifying purchases. Prices and availability are accurate as of the date shown and are subject to change.

This Pinals pack fits shooters who want a common carbon-arrow starting point with a published straightness spec and included 100-grain field points. The 30-inch shaft length, plus or minus 0.003 inches straightness, and plus or minus 1 grain shaft weight tolerance make it useful for a clean chart-based setup.

It is a practical pick for compound shooters who want one box that can work for practice and hunting planning. The tradeoff is that the arrow lineup is broad rather than highly specialized, so buyers still need to verify the current spine against the maker’s selector and their exact draw length.

Gold Tip: best for mixed hunting setups

As an Amazon Associate we earn from qualifying purchases. Prices and availability are accurate as of the date shown and are subject to change.

This Gold Tip Hunter 340 pack suits compound hunters who want a middle-road starting point and a factory-fletched arrow. The 2 inch Raptor vanes and plus or minus 0.006 inches straightness tolerance make it a straightforward option for field-point practice that can move into hunting setup work.

It is a sensible choice when the chart points toward a common hunting spine and the shooter wants less prep before assembly. The tradeoff is that the tolerance is looser than the Pinals option here, so buyers who want a tighter shaft spec may want to check whether the chart and shaft family still fit their build.

Which one should you buy?

If your setup is a longer cut arrow, heavy on the front end, or headed for fixed blades, choose the stiffer-leaning option from the maker’s selector first. That usually protects hunting tune better than chasing a weaker number on the chart.

If your setup is shorter, uses lighter point mass, and stays with field points or mechanical heads, the chart-center choice is often enough. For a mixed-use build, the best answer is the one that matches the shaft maker’s current chart and leaves room for broadhead tune.

Between these two products, the Pinals arrows make more sense for a buyer who wants a tighter published shaft tolerance and included 100-grain points. The Gold Tip Hunter 340 makes more sense for someone who values a familiar hunting shaft and factory fletching more than a tighter straightness figure.

Before checkout, confirm the current selector from the shaft maker for your exact bow speed, draw weight, and cut length. Manufacturer-specific charts differ, and the same static spine can land differently across Easton, Gold Tip, Victory, Carbon Express, and Black Eagle families.

Similar Posts